Torque Solution Solid Differential Bushing w/ Urethane Inserts: Mitsubishi Evolution X MR & GSR 08+

The solid differential mount will eliminate movement of the rear end in

the subframe. By replacing the rubber mount with this solid 6061 billet

get rid of the unwanted slop and flexing of the stock units which allows

for the power to go into rotating the tires, instead of flexing the

rubber. Giving you better feedback, sharper response, more

predictability on throttle input, along with eliminating annoying

clunking during hard shifts.

• Reduces the " CLUNK " when shifting hard
• Reduces wheel hop / traction loss
• Improved 60fts / e.t's
• Road Race torture tested
• 6061 anodized billet
• 25% Lighter than Stock
• Limited Lifetime Warranty
• These

Solid Polyurethane bushings are much harder compared to the OEM units.

By replacing them with these harder Polyurethane units you are able to

get rid of the unwanted slop and flexing of the stock units which allows

for the power to go into rotating the tires, instead of flexing the

rubber. Giving you better feedback, sharper response, more

predictability on throttle input, along with eliminating annoying

clunking during hard shifts.

• Eliminates the " CLUNK " when shifting hard
• Reduces wheel hop / traction loss
• Improved 60fts / e.t's
• 95A durometer bushings
• Limited Lifetime Warranty

Install Tip: Thinner bushing goes on top and thicker on the bottom.

Vehicle Fitment

• 2008 Mitsubishi Lancer
• 2010-2015 Mitsubishi Lancer

Please verify exact fitment for your trim and engine before ordering.

Manufacturer Part Number: TS-EVX-003

Images are for illustrative purposes only. Actual product may vary.

⚠ WARNING (California Proposition 65): This product can expose you to chemicals which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov.