Skunk2 Universal Intake Kit 3.5in Coupler w/Mounting Ring

The Skunk2 Universal High Velocity Intake Kit reduces heat soak and maximizes airflow and velocity for any induction system. The kit utilizes a massive 6.8 in. diameter high-flow low-restriction air filter that features a unique double-cone design where the inverted inner filter cone not only increases the filter surface area and air flow capacity, it also helps reduce turbulence inside the filter and guide the incoming air to achieve higher flow rates and velocities. Included with the filter is a unique Composite Velocity Stack that incorporates golf ball like dimples on the surface. These dimples create an energized boundary layer that reduces surface drag and allows air to stay attached as it curves into the bell mouth. The result is higher air velocities and increased air mass delivery to the engine. When we flow tested a conventional air filter design against the Skunk2 filter and used advanced CFD analysis program, our filter flowed 20% more air-mass, which translates to signific

Application: Universal — verify fitment for your setup. This is a performance/fabrication component not tied to a specific vehicle year/make/model.

Manufacturer Part Number: 343-99-0615

Images are for illustrative purposes only. Actual product may vary.

Emissions Note: This product is not CARB approved and is not legal for sale or use on pollution-controlled motor vehicles in California, or in states that have adopted California emission standards. It is intended for off-road / racing use only. It is the responsibility of the installer/end-user to ensure compliance with all applicable federal, state and local emissions regulations.

⚠ WARNING (California Proposition 65): This product can expose you to chemicals including lead and lead compounds, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.